Đăng nhập
 
Tìm kiếm nâng cao
 
Tên bài báo
Tác giả
Năm xuất bản
Tóm tắt
Lĩnh vực
Phân loại
Số tạp chí
 

Bản tin định kỳ
Báo cáo thường niên
Tạp chí khoa học ĐHCT
Tạp chí tiếng anh ĐHCT
Tạp chí trong nước
Tạp chí quốc tế
Kỷ yếu HN trong nước
Kỷ yếu HN quốc tế
Book chapter
Bài báo - Tạp chí
Số Renewable Energy 2016 (2016) Trang: 46-51
Tải về

ARTICLE INFO

 

ABSTRACT

Received date: 25/01/2016

Accepted date: 08/07/2016

 

Helical heat exchangers are commonly used to exchange the thermal energy in waste heat recovery systems. Ammonia rectifier in absorption chiller and heat recovery steam generator are examples typically found in open literature. They are widely employed because of its compactness, high heat exchange rate, compensation of thermal expansion, vibration resistance, simple construction, and low capital cost. Heat exchanger researches have almost focused on straight tubes. However, study on helical heat exchanger has not been paid attention. In this study, a simplified model is developed to predict single phase heat transfer and pressure loss in the helical heat exchanger under various operating conditions without geometrical information inside the exchanger required. Methods of LMTD and e-NTU, and selective empirical correlations are presented in the model. Simulation results were achieved good agreement with the experimental data with a moderate tolerance. The model would be expected as a good tool for designers to the pre-design and correct selection of helical heat exchanger in thermal network.

KEYWORDS

Helical heat exchanger, Modelling, Experimental validation

Cited as: Phu, N.M., Huy, H.T.T, Truyen, L.T. and Tho, T.T., 2016. Prediction in off-design operation for the helical heat recovery exchanger. Can Tho University Journal of Science. Special issue:  Renewable Energy: 46-51.

 

CTUJoS indexed by Crossref

Vietnamese | English


BC thường niên 2018


Con số ấn tượng (VN | EN)


Bản tin ĐHCT


TCKH tiếng Việt


TCKH tiếng Anh

 
 
Vui lòng chờ...